Camera "Duckbill" Sun Hood Dji Phantom 2 Vision+ Rev 3 MR Droneworx Fix strobing

Duckhood-Side.jpg
Duckhood-table.jpg
2014-06-15 17.54.47.jpg
Duckhood-Top.jpg
2014-06-15 17.54.55.jpg
Duckhood-Side.jpg
Duckhood-table.jpg
2014-06-15 17.54.47.jpg
Duckhood-Top.jpg
2014-06-15 17.54.55.jpg

Camera "Duckbill" Sun Hood Dji Phantom 2 Vision+ Rev 3 MR Droneworx Fix strobing

19.95

This is a custom designed 3d printed hood for the DJI Phantom 2 Vision+. After flying the original for months and selling hundreds, I found a number of improvements I could make. This is my Rev 3 "Duckbill" version. The needs of a sun hood for multi rotors are very different than the needs of a traditional camera. I designed this duckbill version to provide the maximum side angle protection from sun flickering. improved the fit, easy of taking it on and off, I also improved my production process so my hoods are now significantly stronger without adding weight. Do you ever get flickering in your video in mid morning or afternoon? This is caused by the sun passing through the props, then onto the lens of the camera. The solution? Prevent the sun from hitting the camera lens at those angles. This drastically improves the image quality in some situations, is extremely light, and is designed to remain on with the gimbal brace installed for transport. For a little thing this took me quite some time to design it right so it provides maximum sun protection, and not get in the frame even when shooting full resolution raw which is a much bigger area than is displayed in the output monitor. It was also important to me to be able to leave it on even when the gimbal is braced for travel. I print these from ABS because of its mat finish and strength. ABS does have a slight size variance based on temperature so I designed these to fit well in most conditions. After countless iterations here it is!

Quantity:
Add To Cart